Crud mk 1 tail

[cyberknight]

Has anyone got a mk 1 tail piece lieing around, mine got pulled off when i did an undergrowth dive and i could not find it !


I only need the 1 piece that fits at the back of the wheel , the front part does not fit

 

[ColinJ]

I've probably got one. I'll have a look later.

I can't remember if the tail pieces for the front and rear are the same. Which one do you need (if they are different)?

 

[cyberknight]

The front bits are smaller and they do not fit , i tried .

It is the rear bit i need thanks for looking

 

[ColinJ]

The front bits are smaller and they do not fit , i tried .
It is the rear bit i need thanks for looking

I meant - is the rear bit of the rear the same as the rear bit of the front! I'm pretty sure it is, because I don't remember there being three sizes (nose of front, tail of front, tail of rear).

PM me your address and I'll pop one in the post tomorrow together with a spare nut/bolt.

 

[cyberknight]

Yes they are i tried the on i have left and it fits both ends


Thank you !!

PM sent.

 

[ColinJ]

Yes they are i tried the on i have left and it fits both ends

Thank you !!

PM sent.

I found a spare tail piece in my junk box and will post it tomorrow.

 

[cyberknight]

Just the Job thanks !

 

[ColinJ]

Just the Job thanks !

No problem!