1980s hub

[spiderman2]

Trying to find any info on these hubs from the 1980s ,cant see how to remove cage bearings?

 

[rogerzilla]

Are they caged? Decent hubs rarely use cages.

 

[Paulus]

Looks like normal cup and cone bearings.
Take all the nuts, locknut and cone off of that side of the axle, and the axle should slide through the other side.
The red part will either come out on it's own, or may unscrew from the hub to reveal the bearings.
Large flanged hubs look great.
What is the name stamped on the hub?

 

[Punkawallah]

Remembering the nimbly catch the cascading bearings :-)

 

[Juan Kog]

Remembering the nimbly catch the cascading bearings :-)

My method ,spread white sheet on garage/workshop floor then dismantle hub while kneeling down .
I learnt the hard way , the little blighters don’t escape now.

 

[midlife]

Are they Lambert / Viscount hubs?

 

[spiderman2]

Looks like normal cup and cone bearings.
Take all the nuts, locknut and cone off of that side of the axle, and the axle should slide through the other side.
The red part will either come out on it's own, or may unscrew from the hub to reveal the bearings.
Large flanged hubs look great.
What is the name stamped on the hub?

No name on the hub but are mavic rims.I will remove red cover again and take another photo.The rear hub is the same,I have removed red covers and cones but axle wont come out?.

 

[Paulus]

No name on the hub but are mavic rims.I will remove red cover again and take another photo.The rear hub is the same,I have removed red covers and cones but axle wont come out?.

Here is a link that may be of some use.
It's a bit long but does get to how to change sealed bearings if that is what you have.

https://viscount-lambert-bikes.blogspot.com/2011/05/sealed-bearing-hubs.html?m=1

 

[spiderman2]

Here is a link that may be of some use.
It's a bit long but does get to how to change sealed bearings if that is what you have.

https://viscount-lambert-bikes.blogspot.com/2011/05/sealed-bearing-hubs.html?m=1

Thanks for reply,I think they are sealed bearings with the outer seal left off.I will have another look later.Thanks

 

[spiderman2]

Here is a link that may be of some use.
It's a bit long but does get to how to change sealed bearings if that is what you have.

https://viscount-lambert-bikes.blogspot.com/2011/05/sealed-bearing-hubs.html?m=1

Took red covers off,one side has washer that doesnt come out and the other side is bearing behind washer.axel does not tap out from either side.may be just clean and leave alone.