I've got this red frame

[micamb]

It's got the shadow of a large 3 point shield on the front, light, fillet brazed and a cotter bb that has no visible cups. Can anyone help me?

 

[steveindenmark]

Post a photo. It will make it a lot easier.

 

[rbreid]

Photo's of Bottom Bracket, headtube, dropouts, fork crown, rear brake bridge, seatpost clamp area. Frame number and whether the frame number is repeated on the steerer tube. These are all essential for an accurate ID where no decals or headtube badge are in place. Was the headtube badge rivetted or a stick on? Is the bottom bracket shrouded at each end or bare? Always willing to spend time on identification but need all the above to go on. Should also say I don't do "I thinks". Positive ID only or an honest don't know.

 

[micamb]

I took ssome

Photo's of Bottom Bracket, headtube, dropouts, fork crown, rear brake bridge, seatpost clamp area. Frame number and whether the frame number is repeated on the steerer tube. These are all essential for an accurate ID where no decals or headtube badge are in place. Was the headtube badge rivetted or a stick on? Is the bottom bracket shrouded at each end or bare? Always willing to spend time on identification but need all the above to go on. Should also say I don't do "I thinks". Positive ID only or an honest don't know.

Thanks for replying. I got the axle out easily (no protection, no inscription) but can't see any way to remove the inverted cups. Number L60269. The stuck on logo was 2.75'' wide by 2.5''- a shield with 3 level points at the top, parallel sides and round bottom. I took some pics but don't know how to export with Ubuntu.

 

[Cycleops]

You won't be able to post pics until you have put up a few more posts. You will then see a "Upload File" button then you will be asked to choose a file on your computer, select and upload. Files could be too large so you might have to crop them with a resizing tool.