Snorrarcisco
Regular
- Location
- Kent
Right I will try to explain in as much detail as possible.
I have some Shimano RX31's and some spyre trp mechanical discs. In order to put both together i have needed to use a Shimano SM-RTAD05 disc rotor adapter. So far I should have no issue.
Disc rotor adapter and disc aligned perfectly.
One slight issue. The adapter comes with a shiny metal spacer smooth on one side and grooves on the other. not sure where this goes but I assume between adapter and rotor this is probably 2 mm thick.
Now the major issue is this if I bolt this down to the adapter the bolts will stick just a fraction out and the shimano lock will not tighten all the way downed sits over the bolts...
Am I need of new shimano proper rotors and therefore new brakes???
Anyone had experience with this issue?
I have some Shimano RX31's and some spyre trp mechanical discs. In order to put both together i have needed to use a Shimano SM-RTAD05 disc rotor adapter. So far I should have no issue.
Disc rotor adapter and disc aligned perfectly.
One slight issue. The adapter comes with a shiny metal spacer smooth on one side and grooves on the other. not sure where this goes but I assume between adapter and rotor this is probably 2 mm thick.
Now the major issue is this if I bolt this down to the adapter the bolts will stick just a fraction out and the shimano lock will not tighten all the way downed sits over the bolts...
Am I need of new shimano proper rotors and therefore new brakes???
Anyone had experience with this issue?