1980's Bianchi Caurus 908.

Page may contain affiliate links. Please see terms for details.

Illaveago

Legendary Member
I am the proud owner of a 1980' Bianchi Caurus ( very strong North westerly winds). Thanks Norbert!

I picked it up at the weekend on our way back from Portsmouth.

The bike is finished in a faded light red pearlescent and black which now looks pink, perhaps a red version of the Celeste minty green which you normally see Bianchis painted in. Not normally a colour I would choose but it is growing on me.

The first thing to do once I got it home was to give it a clean and try to see if the colour would polish up. It was lacquered so no amount of polishing would bring the colour back. I did notice that it wasn't a straight colour but was a pearlescent and sparkles in the sunlight. I find it strange that the crossbar has black partially sprayed on it at the front as if the sprayer walked out halfway through doing the job. :wacko:

As I wanted to try the bike out as soon as I could I needed to replace the rear tyre for a road one. As luck would have it the new tyre I had in my garage was a 27 inch one and I needed a 700. I soon found one on a spare wheel and swapped them over. I thought that the frame was a bit on the small side so I tried to raise the saddle. It is seized! Spraying it with release spray and boiling water on the frame didn't work so I have left that for the time being. Having sat on the bike the present position seems fine.

My test ride this morning went well despite feeling a bit tired and a strong gusty wind. The ride is really smooth. I did my usual ride over to my brother's. It's a route I use regularly so I can easily compare bikes. I really like it! Another ride on a better day is required.

20260905_163119.jpg


20260906_153955.jpg
 

biggs682

Itching to get back on my bike's
Location
Northamptonshire
Glad you have saved another one just need to free things off next
 

Gunk

Guru
Location
Oxford
After you've doused it with Plusgas, try taking the wheels and saddle off, turn it upside down and put the seat post in a vice and use the frame as leverage, usually works.

If that fails then it's a hacksaw blade in a sawn off broom handle and carefully cut the seat post longways, takes about half a day!
 
Top Bottom