Bike frame collage

Page may contain affiliate links. Please see terms for details.

B_A_Brackers

Regular
I have seen a few frames covered with comic book cut outs and have a high quality looking finish. I have a steel frame that has been stripped down and am wanting to do this however am not sure how to go about it. I read that is is done by just applying cut outs to frame with epoxy and then painting epoxy over the cut outs before spraying on an acrylic. Anyone any experience in this
 

vernon

Harder than Ronnie Pickering
Location
Meanwood, Leeds
 
OP
OP
B_A_Brackers

B_A_Brackers

Regular
20150406_16483720150406_164837_zpsesvdagvr.jpg


Cut it up small and stick it on with waterproof glue and seal with a coat of varnish.
@User
What sort of glue and varnish should I use
 
Top Bottom