gaz
Cycle Camera TV
- Location
- South Croydon
I've just replaced my standard ultegra pads with some kool-stop ones.
But after finishing the job, taking a step back and admiring my bike and the work i had done. I felt something was wrong.
I did each brake block one by one so i wouldn't get mixed up. But i still think a previous fault in the last time i changed them now means they are currently wrong.
The small bolt that holds the bad on the block is always on the side of the brake that is facing towards the front. Is this right? or should it always be at the back side?
But after finishing the job, taking a step back and admiring my bike and the work i had done. I felt something was wrong.
I did each brake block one by one so i wouldn't get mixed up. But i still think a previous fault in the last time i changed them now means they are currently wrong.
The small bolt that holds the bad on the block is always on the side of the brake that is facing towards the front. Is this right? or should it always be at the back side?