Hi
I'm tuning my company rear mech and it's driving me mad.
High and low screws are bang on, I've wound the barrel adjuster in and then out a couple of turns, connected cable.
Going from the small cog to the large cog is fine, but going back to the small cog is a nightmare, the first 3/4 gears are fine and then the next 2 won't engage unless I loosen the barrel but then when I go to go from the small to the large cogs again I have to tighten then barrel again.
It's only the middle of the cassette that's the problem.
Any ideas.
I'm tuning my company rear mech and it's driving me mad.
High and low screws are bang on, I've wound the barrel adjuster in and then out a couple of turns, connected cable.
Going from the small cog to the large cog is fine, but going back to the small cog is a nightmare, the first 3/4 gears are fine and then the next 2 won't engage unless I loosen the barrel but then when I go to go from the small to the large cogs again I have to tighten then barrel again.
It's only the middle of the cassette that's the problem.
Any ideas.