andsaw
Senior Member
Thought i would post this here not sure if its in the right section but here's an easy way to fit them or adapt a way for your bike http://www.crudproducts.com/products/roadracer/roadracer___
Crudracer mk 2 mudgaurds fitting
- Thread starter andsaw
- Start date
Page may contain affiliate links. Please see terms for details.
Nocode
Senior Member
- Location
- Orpington, Kent
Thank you. I will be using that video to fit my Crud Racers when they turn-up. Ordered them this morning!
Steve Saunders
Active Member
- Location
- Dundee, Scotland
I was having a bit of trouble fitting mine using the instructions supplied in the box, just could not get them fitted without rubbing. It was only after watching the video above that I got them properly fitted.
I would also advise using electrical table to protect the forks and seat-stays where the mudguard "feet" meet the frame, as without doing this you will likely end up with fine scratching to the paintwork due to the slight movement/flex in these mudguards - it happened to me after 1 x 50 mile ride along country roads in the wet.
I would also advise using electrical table to protect the forks and seat-stays where the mudguard "feet" meet the frame, as without doing this you will likely end up with fine scratching to the paintwork due to the slight movement/flex in these mudguards - it happened to me after 1 x 50 mile ride along country roads in the wet.