SuperGalactian
Well-Known Member
I usually buy a good map that covers the area I'm going to cycle in and then photocopy onto A4 sheets a selection of relevant parts. If there are any off road cycle ways that are not clearly shown, I will pencil or ink them in and then use one A4 map print-off at a time in my mapholder, keeping the rest nice and dry in a plastic cover inside my bar bag along with the master map. (I generally then use any rest breaks to ink in or highlight the route that I have actually taken so far).
I use a Rixen & Kaul Klickfix bar bag that is big enough to keep my valuables, my rain jacket, food and drink, a spare tube and some tools in, along with the map and (folded) spare map sheets.
View attachment 822549
I've had it for a few years now, and like the fact that it is so inter-changeable with my smaller bar bag that I use for most rides from home. After a few years the plastic map cover did start to become a little cloudy, and the velcro used to seal it shut has started to detach, but I don't mind adding a little sellotape to fix that, and I still like the bag and would recommend it. It would be nice if you could buy a replacement map cover, though. There is also a very slight issue with the map cover inflating a bit when speeding downhill, showing that it is not quite air tight .... though I've never had any water ingress. (Just giving you a completely honest review. I would still recommend it).
Thanks for that. I think that’s the same bag that I have had for about 20 years, except mine was badged Altura. The Velcro has come off its map case, and had to be stapled as well as glued back. It will just - only just - take 2 panels of an OS map without the card cover, but changing to the next panel is a pain. I should do as you do and make photocopies that can be shuffled about inside the case.