Perils of buying 2nd hand and goings on in my garage

Page may contain affiliate links. Please see terms for details.
OP
OP
biggs682

biggs682

Itching to get back on my bike's
Location
Northamptonshire
Yeah, just about, currently riding a 63cm Kinesis, and that's a nice looking bike.... Still waiting for the right moment to get my Pug repaired so not got a vintage steel atm...

It's 25" from centre of bottom bracket to the centre of the seat pinch bolt and just over 22" centre to centre along the top tube
 

si_c

Guru
Location
Wirral
It's 25" from centre of bottom bracket to the centre of the seat pinch bolt and just over 22" centre to centre along the top tube
Just had a look on Geometry Geeks and it's very close to the RTD, longer chainstays but similar wheelbase, I can't find stack and reach figures for it which makes a direct comparison difficult even though the RTD has a relatively traditional geometry the TT is still slack.

Nice looking bike though for sure. :whistle:
 
OP
OP
biggs682

biggs682

Itching to get back on my bike's
Location
Northamptonshire
Just had a look on Geometry Geeks and it's very close to the RTD, longer chainstays but similar wheelbase, I can't find stack and reach figures for it which makes a direct comparison difficult even though the RTD has a relatively traditional geometry the TT is still slack.

Nice looking bike though for sure. :whistle:

As if like magic

IMG_20250622_163750.jpg


IMG_20250622_163812.jpg


IMG_20250622_163820.jpg


IMG_20250622_163827.jpg
 
Last edited:
OP
OP
biggs682

biggs682

Itching to get back on my bike's
Location
Northamptonshire
Forgot to post this earlier.
Thought I would use the Galaxy on this morning's ride so started of with the intention of doing one of my normal loops and extending it if the bike was going well ended up covering 35 miles which included some off roading after climbing up to Whiston church to regain the road.

IMG_20250622_071023.jpg
 
OP
OP
biggs682

biggs682

Itching to get back on my bike's
Location
Northamptonshire
New tyres arrived today so once I finished a job on the car I thought I had half an hour before lunchtime so thought I would get them fitted.

Well two hours later they were finally mounted on rims , boy they were an absolute pain to fit as they are very tight .

Whilst I had the rear wheel out I thought I would service the hubs which was much needed as all the ol' grease had dried out.

Also gave the screw on block a bit of a cleaning in between the gears .

Certainly a bit more clearance and hopefully a set of guards should fit now.

IMG_20250712_151308.jpg


IMG_20250712_151322.jpg


IMG_20250712_151327.jpg
 
Top Bottom