Hello
Just become an owner of a set of the above rollers.
Now I have noticed what I feel could be a design flaw or are they not working correctly.
These rollers as those of you have them or know them slide in and out and lock at the desired
setting. When I pull them out to the desired setting length all is OK, now once the band
is connected between the back and front roller that side of the frame where the band is pulls back about half an inch, then after a little use it has pulled back a little further and the other side of the frame has also pulled back from the desired length setting.
Now surly this is due to a bad locking system design not working correctly ?
Anybody else have these rollers ? If so have you noticed this or found a cure for it other than sending them back with a complaint.
EDIT : Think I was using this incorrectly, I thought the levers on either side where used to lock it in place whilst in use, and the bolt heads just acted as stops for the right length. Well that's how the instructions show it, but as I have said this does not work correctly, it moves.
I have found that by slackening what I thought were stop bolts, pulling the frame to full length, then tighten said bolts holds it all in place, so therefore the grey levers would be for the storage transport side of things.
I have revisited the instructions and it does show that you use the grey levers to lock it in place
Just become an owner of a set of the above rollers.
Now I have noticed what I feel could be a design flaw or are they not working correctly.
These rollers as those of you have them or know them slide in and out and lock at the desired
setting. When I pull them out to the desired setting length all is OK, now once the band
is connected between the back and front roller that side of the frame where the band is pulls back about half an inch, then after a little use it has pulled back a little further and the other side of the frame has also pulled back from the desired length setting.
Now surly this is due to a bad locking system design not working correctly ?
Anybody else have these rollers ? If so have you noticed this or found a cure for it other than sending them back with a complaint.
EDIT : Think I was using this incorrectly, I thought the levers on either side where used to lock it in place whilst in use, and the bolt heads just acted as stops for the right length. Well that's how the instructions show it, but as I have said this does not work correctly, it moves.
I have found that by slackening what I thought were stop bolts, pulling the frame to full length, then tighten said bolts holds it all in place, so therefore the grey levers would be for the storage transport side of things.
I have revisited the instructions and it does show that you use the grey levers to lock it in place