Anyone got an old 12t cassette lock ring going spare?

Page may contain affiliate links. Please see terms for details.

ChrisEyles

Guru
Location
Devon
Just need the lock-ring itself, not the 12t sprocket.

It's for an 8 speed cassette if that makes any difference. Going to use it to tidy up a SS conversion, currently I'm using an 11t sprocket & lock-ring to hold everything together, since the 11t lock-ring is too small to grip a spacer.
 
@ChrisEyles I have one from a twelve , from a shimano hyperdrive cassette, pm your address if its suitable and I will post on monday
.. 20190216_123235.jpg 20190216_123224.jpg
 
OP
OP
ChrisEyles

ChrisEyles

Guru
Location
Devon
Just swapped over the old 11t sprocket and lock ring for an ally spacer and @roadrash's 12t spacer and looks much better. Also replaced the extraneous sprocket nearest the centre of the hub with a second ally spacer, and settled on a single sprocket rather than the "can't decide so I'll have two" that were on there before.

Looks loads smarter now!

Before:
P1090718.JPG

After:
IMG_20190221_180213.jpg IMG_20190221_180235.jpg

It's still not quite a proper single speed as I've still got the big and middle rings on the crankset, but when I've needed that lower gear I've sure been grateful it's there in reserve!

Thanks again @roadrash, you're a true gent :smile:
 
Top Bottom