User1314 said:
How do you lot find the puncture hole in the open? I can never find the hole without use of bucket or sink full of water, so I just carry a couple of spare tubes.
Use tyre lever to remove one side of the tyre from the rim.
Pull out inner tube (but not completely, leave the value in the rim).
Put a bit of air in the tyre with a pump, listen closely for hissing (the more air you put in the louder it should be, but don't do too much as the tyre doesn't like being stretched unconstrained by a tyre).
Close in on hissing sound by running fingers lightly over the tyre, the hiss sound will change pitch and loudness when pass over the hole.
A bit of saliva, or water from bidon, can be used to confirm (but then you'll only have to dry the area before you patch it so I rarely bother.)
When you've found out where the hole is, put the inner tube up against the tyre to see where the cause of the puncture should be located and check that general area (a good 3" either side too) for glass/thorn/flint/etc.
If the hole(s) is on the inside of the tube then check the rim tape hasn't come away exposing a spoke.
Also, there's a chance that the hole will be right next to the valve, so if you still can't find it after searching for a while, try removing the tube completely and checking there.
Obviously, listening for a gentle hiss next to roaring traffic is nigh on impossible. Either move away from the traffic or just try and find it by putting the air in and feeling for a thin jet of air on your fingers as you search round the tyre.
If it's been throwing it down with rain then you can often find a puddle and resort to the old water method.