I only had a quick look at first but have now watched it all, and subscribed to the channel too. I think his miniature drilling machine is the design I've got a book about making. I did have a lathe in my previous life, albeit a bit bigger, but sadly I ended up leaving it behind
I only had a quick look at first but have now watched it all, and subscribed to the channel too. I think his miniature drilling machine is the design I've got a book about making. I did have a lathe in my previous life, albeit a bit bigger, but sadly I ended up leaving it behind
I think it's the first time I've watched a whole half hour video on YT, and I did it without noticing the time. Then I watched one of him making a 0.6mm screw, then a gear for a watch. Drilling a 0.4mm hole through the middle of a 0.8mm rod is impressive.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.