I can't find my nuts

[Alien8]

I'm trying to source some nuts for a Novatec front track hub axle.

These are ones that go up against the cartridge bearing - not to hold the wheel in the fork.

9mm axle, 1mm pitch (I think), ~4mm thick, takes a 17mm spanner.

Can't find anything remotely similar.

Any ideas?

 

[numbnuts]

ebay, but check on the pitch

 

[rogerzilla]

Most Japanese or other Far Eastern front wheel cone locknuts will do the job. Just check the thickness is close enough. Be wary of very cheap stuff, which may be 5/16", or Campagnolo which may be 26tpi (half metric, half imperial!).