Need help!

Discussion in 'Fixed Gear and Single Speed' started by fixolydian, 27 Jan 2008.

  1. fixolydian

    fixolydian New Member

    I Just recently changed a puncture on my fixed gear, after replacing the wheel when I tightened the tracknut up on the drive side when it got halfway tight it just keeps turning, I can't fully tighten it, it just keeps going round. Have I threaded the axel or would a new tracknut do? Problem is I am not sure if I can remove it, will try later today.
    I have cheap formula hubs,is it fixable or is the axel probably bust? Or time for a new better hub?

    cheers!
     
  2. Sounds to me like you might have stripped the thread, although that would take quite a lot of torque to do. If you have, you'll need a new axle and new tracknuts. Have you tightened up the other side? It's possible that the whole axle is turning, rather than just the nut.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice