New version of tyre is (much) smaller than outgoing model... am I within my rights to return them?

Page may contain affiliate links. Please see terms for details.

Ajax Bay

Legendary Member
Location
East Devon
All I wanted was something 2-3mm taller/wider.......
And you didn't get it, did you. Good advice from @potsy, but for next time.
 

Ajax Bay

Legendary Member
Location
East Devon
If you get special pleasure from succeeding in an epic struggle to fit a tight tyre which is a 'mare to get on a rim, then do not use talc. And also expect to struggle by the roadside the first time it needs taking on and off.
 

Ajax Bay

Legendary Member
Location
East Devon
To measure a tyre section, ETRTO has defined:
  • The rim width on which each tyre section must be measured
  • The pressure at which it must be measured, taking into account that the casing of a brand new tyre will stretch within the first 24 hours of inflation, so the measurement should be done after those 24 hours
For example, a tyre said to be a section of 23mm should be measured on a rim of 15mm internal width at 6 bars (87 PSI) after 24 hours.
A tyre said to be a section of 28mm should be measured on a rim of 17mm internal width at 6 bars (87 PSI) after 24 hours.

the-right-tyre-width-on-the-right-rim-width/
 

Poacher

Gravitationally challenged member
Location
Nottingham
Must be a youngster that posted that!
:rofl:
 

ayceejay

Guru
Location
Rural Quebec
Sure enough the new gap is bigger


toblerone.jpg
 
Top Bottom