Tea? (Part 2)

Status
Not open for further replies.
Page may contain affiliate links. Please see terms for details.

Arch

Married to Night Train
Location
Salford, UK
NT, you probably already prepared for it but please make sure you spread the point load from a full bath over several joists not just on packers on the floorboards. If you're leaving the bath open, you might need to double up the joists underneath the feet.

Oh yes, this has been discussed....:thumbsup:

And I think the plan is to box it in. The legs are pretty, but not that pretty, and the outside of the bath would need painting or something.
 

Renard

Guest
This is my bath in place. It will move out again as I do work but that is where it will sit in the end.
View attachment 16991
...I would get a blind for that window!
 

Night Train

Maker of Things
NT, you probably already prepared for it but please make sure you spread the point load from a full bath over several joists not just on packers on the floorboards. If you're leaving the bath open, you might need to double up the joists underneath the feet.
Yes, the position is just to work out how it fits, if there will be enough head room, and how much packing is needed to get it level. The bath will be boxed in so nothing will show.
I will likely have 1+" thick oak boards to spread the weight over the three joists under the bath. I may also put some steel plates between the feet and the oak as the feet seem to land 'on point'.

The only thing I am doubtful of is if the three 6"x2" joists are really up to the task. The wall on the right is a supporting wall while the wall on the left is a partition and the joists extend another 10' to the next supporting wall.
A future job is to remove the ceiling underneath as the plaster boards are loose anyway. At that time I can add additional joists if needed.

However, if you have concerns I will heed them and redesign the room layout.:smile:
 

Archie_tect

De Skieven Architek... aka Penfold + Horace
Location
Northumberland
Rule of thumb for joists at 400 centres [with uniformly distributed domestic load]:depth of joists is half span [measured in feet] in inches + 2": ie 6" joist can span 8 feet [8' span x 0.5 = 4 + 2"] under uniform domestic load.

These should be doubled up where bath runs parallel with joists ideally. Under the bath you need full depth blocks between the joists and the bath feet ideally placed over joist lines. [Cross spreading timber plates will help distribute load but you're best calculating the actual load under the bath as a double check]

For guidance have a look at Building Regs Part B on line for various loads for joist spans.
 

Arch

Married to Night Train
Location
Salford, UK
Then you can take it for a spin. :laugh:


NT has his tumbledryer on top of his washing machine, in a cupboard in the bathroom. There was a door on the cupboard, but he's taken that to use on the new guestroom.

This has allowed me to see for the first time, how much the pair wobble about when the washer is on spin cycle! :eek: *

There's an iron on the top of it all, and I'm thinking of rigging up a sheet of paper above it, taping a pencil to the point of the iron pointing up, and seeing the spirograph style pattern that ensues!

*NT says he's well aware and makes sure he adjusts them if they get out of kilter. It's all fine. Really. Fine.
 
Status
Not open for further replies.
Top Bottom