Seal and clock on liftoff back on schedule?
You reckon there's sufficient pressure in yer water for lift off. And that all important "Wow" moment...
Too wet, even for you, to venture out. It were that bad.
Crying on into yer cuppa after you've had the second extraction. Something special required at the GC cafe methinks. Nowt too expensive though...
Should NASA and Musk be bothered by the fact you've projects in the pipeline.
That's a printed vase?
How tall can your printer print?
Logging up gets earlier every week. Yer "skunk work" projects must be keeping you busy at night.
SAmer and other stuff just pops up! Sounds dodgy.
It is a printed vase...aye..by the printer as asked by me...
240 x 240 x 240 safely I'd say, bed is 256 x 256 x 256 mm.
I'd probably never try anything above 230 tbh but you also get stuff like a brim being printed first if the print is small walled and say hollow etc..it sizes depending on the article size but the printer will tell you if not okay..
when you 'slice' a file into its printed STL file....
The website I get 90% of my prints, gives you.
I can cut out the preample it goes through, checking a lot of settings including a self levelling check, I did a self levelling maybe twice a week with the old one, if anyone reading this is thinking of buying one, please get a self-levelling one. My first one was not..it's a chore..
anyhow it takes quite a few mins, next print I'll post the time of print etc
There ya go.....
Middle see Time Estimation, 6 mins 30 secs of preparation....
The green 'slider' after I 'slice', it lets me take it back to any part of the job and insert a pause to say change of filament, you do the necessary just like that..see the rocket image I posted earlier this week...or the OO toob clip (it has had 439 views).
Makerworld (the website is part of the BLabs system is all tied up with Bambu Print so handy.
Forgot to say, the vase is very flimsy tbh, I must see if I can sturdy things up....more a decoration, dried flowers perhaps.
The design is impressive in real life...
Wait until you see my toadstool slug trap....
Jet wash teeth time today, in 75 mins. aaaaaaaaaaaaaaaaagh.
Logging? I'm happy when i get to a stage, gotta leave some bread on the table..
to warm you up.....
