Just wondered if you had seen this article @classic33
https://www.bbc.co.uk/news/articles/c30rrm4z1ggo
https://www.bbc.co.uk/news/articles/c30rrm4z1ggo
Tea?
- Thread starter 172traindriver
- Start date
Page may contain affiliate links. Please see terms for details.
classic33
Leg End Member
You becoming one of those there "influences", showing how things should be done?Did I mention yon YouTube short of the PLA spool, over 1.4 k views
I'll take that, most views out of the shorts I have posted...
Dat'll do me...
Supports, it will put supports on some smaller stuff and will warn you that some supports are needed, track down down Supports, I use Tree Auto which works out where to put them, I find tree is the easiest to work and remove,
I'm basically using the suggested settings and TBH no problems so far, one failed print but as everything looked at, it had to be a flaw in a length of PLA on the spool, I finished the last half of spool with no problem, the Red PLA in video.
I'll avoid that make..
Celebration time....
Da boom boom tish !
The overland spool is in Edinburgh and will be hopefully moved to my local one tomorrow...
Making some boxes for my camera lens filters the noo, must she the Boss for some material to line the bottom of each section.
I've made changes to my cleaning regime,
washing up liquid (or as they say, dish soap),
rub all over the plate then dab kitchen towel into water and clean and dry off.
The daily soul food to prepare..
You a bad "influence", or a good un...
Attention spans are getting short these days.
I can understand some supports being needed, but that one you posted where there were more supports on the piece being printed than the actual piece, stood out.
It'll suggest where to place the supports, handy. Saves having to work it out.
Bad PLA. Don't let it play with the rest of them, in the naughty corner to think about what it were doing...
Are there makes that worked with yer "old printer" that are giving problems with yer new one.
I'd celebrate when it gets delivered, not before.
Yer certain it'll be todays tomorrow and not any other tomorrow? You've had at least three "tomorrows" this last week alone.
You didn't keep the cases they came in, shame on you. Or are you after a co-ordinated look. Suppose she says "No", what'll tha do...
That's an odd way of doing the dishes, but each to their own I suppose. Any quicker that way... You could free up some more time for yerself, let the dishes dry on their own, save you the job.
Soul food now eaten...
Was yer milk situation any better this morning.
classic33
Leg End Member
First I've heard of a re-release. I've still got the original single, on tape.
classic33
Leg End Member
Long time no see.Hope you are both as well as can be
Hope yer doing well.
I could be doing better, like winning the lottery three weeks in a row. Doing it might give me a better chance though
