Hi to all and Merry Christmas,
I have been using my Pro2 for about 3 months now on my MacBook Air with an Ant+ dongle, Garmin cadence sensor and Garmin Heart rate sensor.
For Christmas I bought an iPad Pro and downloaded the app. Because I'd forgotten my password I re-set it and tried it on the iPad.
The trainer was re-configured to Bluetooth by the program and seemed to be ok but it didn't show any watts.
Going back to my usual set up on the MacBook Air, the trainer and sensors are picked up in Ant+ mode but as soon as I try to turn the pedals the trainer refuses turn like it is locked.
Not sure what to try now so I was hoping someone would have some advice. I have sent a message to Bkool but don't expect an answer til after Xmas.
As an update, I read a post on here about the simulator not working with IOS High Sierra. My system has just updated to this on the MacBook and the iPad is IOS 11.
Does anybody use the simulator with these?
Thanks in advance
Clarke
I have been using my Pro2 for about 3 months now on my MacBook Air with an Ant+ dongle, Garmin cadence sensor and Garmin Heart rate sensor.
For Christmas I bought an iPad Pro and downloaded the app. Because I'd forgotten my password I re-set it and tried it on the iPad.
The trainer was re-configured to Bluetooth by the program and seemed to be ok but it didn't show any watts.
Going back to my usual set up on the MacBook Air, the trainer and sensors are picked up in Ant+ mode but as soon as I try to turn the pedals the trainer refuses turn like it is locked.
Not sure what to try now so I was hoping someone would have some advice. I have sent a message to Bkool but don't expect an answer til after Xmas.
As an update, I read a post on here about the simulator not working with IOS High Sierra. My system has just updated to this on the MacBook and the iPad is IOS 11.
Does anybody use the simulator with these?
Thanks in advance
Clarke
Last edited:
