Debian
New Member
- Location
- West Midlands
Today my front mech decided that it wouldn't change into the granny ring, it's been fine up till today.
This evening I decided to adjust it but try as I might I cannot get the full range of shifting. I can get high and middle, or middle and low but not all three. And it's not even that good then = if I change into top I then need to drop two clicks to get the chain back onto the middle ring after which I can change back up into two and the chain then happily stays in two.
What do you reckon? Knackered deraileur? I think it must be but before I spen money I'd like your expert opinions.
Thanks in advance.
This evening I decided to adjust it but try as I might I cannot get the full range of shifting. I can get high and middle, or middle and low but not all three. And it's not even that good then = if I change into top I then need to drop two clicks to get the chain back onto the middle ring after which I can change back up into two and the chain then happily stays in two.
What do you reckon? Knackered deraileur? I think it must be but before I spen money I'd like your expert opinions.
Thanks in advance.