Don't want the expense of a bike fit.

Page may contain affiliate links. Please see terms for details.

gavroche

Getting old but not past it
Location
North Wales
After a couple of hours on the bike, my neck and shoulders hurt.
What do I need to adjust to correct it?
A bike fit is expensive and nobody round my way does it anyway so it would involve another petrol expense too.
I would be grateful for any tips you could give me.
 

wafter

I like steel bikes and I cannot lie..
Location
Oxford
I got this when the front end was too low and long - the result of both stretching forward and a lot of posterior rotation at the neck to get my head sufficiently upright to see.

This resulted in stiffness in my upper rhomboids and traps; ultimately leading to some nasty tension headaches originating from this tightness up the back and sides of my neck.

Easiest way to test this would be to fit a shorter stem, flipped to increase the stack.
 
The simple answer is that you either need to get the bars raised or brought closer to you. This is of course assuming that the saddle is in the correct position to start with. Is the stem in the + or - position. If - then flip it. If + then are there any spacers above the stem, if so, put them under. As a rule of thumb, if you sit on the bike holding the tops of the bars look through to your front axle, it should be pretty much obscured by the bars. Remember, this is just a guide. Remember, just do one thing at a time and then try it.
 

All uphill

Still rolling along
Location
Somerset
I'd be very cautious of random people on the internet giving advice (that includes me). This is doubly so when we don't know some basics about you and your bike.

Drop or flat bar, Your age and fitness level, type of bike, whether you take breaks etc, etc.
 

Drago

Legendary Member
Location
The Urban Fringe
As Figgers suggests, theyre may be nothing wrong with your wet up but rather the achiness could be indicative of a physiological issue. Not uncommon for a chap in their 90's like you ;)
 
Top Bottom