Ajax Bay
Legendary Member
- Location
- East Devon
I have a Campagnolo Ventum wheelset where the rear wheel has 24 spokes: spokes grouped in 3s, one non-drive side (NDS), two drive side (DS) in each set (x 8 obv). The DS are 2-cross and the NDS one is radial. [edited] DS can't be radial because that hub flange has torque to transmit.
I have not investigated but I suspect that this means that the spokes are all the same length and also means the spoke tension is similar (as opposed to 1000N DS and 1500N NDS).
I have had fun constructing this diagram, which is illustrative.
Key:
Red - radial NDS
Green - leading
Blue - trailing
I suspect the spoke holes on the flanges are not aligned DS - NDS but offset, to make the three spokes in each set parallel, with equal distance between the NDS and DS spokes (not quite as diagram).
I have not investigated but I suspect that this means that the spokes are all the same length and also means the spoke tension is similar (as opposed to 1000N DS and 1500N NDS).
I have had fun constructing this diagram, which is illustrative.
Key:
Red - radial NDS
Green - leading
Blue - trailing
I suspect the spoke holes on the flanges are not aligned DS - NDS but offset, to make the three spokes in each set parallel, with equal distance between the NDS and DS spokes (not quite as diagram).
Last edited: