clefty said:
Arch, just trying to have a closer look at how you mounted it on the top of your helmet as I'm having trouble keeping it steady using the velcro strap - i seem to end up with too much strap..any help appreciated.
Yeah, I found it a bit of a fiddle to start with, and tried a couple of set ups. I walked in today, so don't have the helmet to hand, but as far as I remember it goes like this:
Using the shorter of the two velcro straps:
Position mount between two vents in required position and try to hold in place with one hand.
Thread strap through one slot on one side of the mount (having stuck on the rubber non-slip patch as recommended in the instructions). Pull through until the buckle is nearly at the mount.
Slot the strap down through the vent on the same side.
Bring it up through the other vent, and through the outer slot in the mount.
Take it back down through the vent (going over the end of the mount), and double back, to run up through the first vent.
Pass it through the buckle, and pull back down through the vent to engage the velcro.
Find you've done the whole procedure with the strap the wrong way round, so that the velcro bits are on the wrong side.
Remove it all, and do again, making sure you turn the strap over...
That's a horribly wordy descirption, I know. I'll try and do a drawing...