Knee position above pedal and seat setback

Page may contain affiliate links. Please see terms for details.

Aston

Well-Known Member
Help needed :smile: I'm a recreational bicycle user, rather than a sporty dashing up hills cyclist, just shortish slow trips on an old Thorn Club Tour, maybe 20-30 miles at a time.

I've realised that my knee position above the pedal is not 'optimal' from everything I've read, dropping a plumb line from my knee cap shows that my seat position should be another 20mm back. Is this a big deal? If I change the seatpost for an additional 20mm setback will I notice a big difference or not for the sort of cycling I'm doing?

I've a Brooks B17 which limits the about of room I have for adjusting the saddle position.

Advice appreciated, thanks
 

fossyant

Ride It Like You Stole It!
Location
South Manchester
Are you sure your saddle is the right height, if it's too low, your knees will be further forward. Rule of thumb is the plumb line should be roughly at the axel. Can you tap the saddle a little further back on the rails.
 

Webbo2

Veteran
Help needed :smile: I'm a recreational bicycle user, rather than a sporty dashing up hills cyclist, just shortish slow trips on an old Thorn Club Tour, maybe 20-30 miles at a time.

I've realised that my knee position above the pedal is not 'optimal' from everything I've read, dropping a plumb line from my knee cap shows that my seat position should be another 20mm back. Is this a big deal? If I change the seatpost for an additional 20mm setback will I notice a big difference or not for the sort of cycling I'm doing?

I've a Brooks B17 which limits the about of room I have for adjusting the saddle position.

Advice appreciated, thanks

Apparently the plumb line thing isn’t necessarily a thing any more especially when lots of bike fitters suggest fitting your cleats as far back as they will go.
Are you having issues with your current position if not why change.
 
OP
OP
Aston

Aston

Well-Known Member
Are you sure your saddle is the right height, if it's too low, your knees will be further forward. Rule of thumb is the plumb line should be roughly at the axel. Can you tap the saddle a little further back on the rails.

No the saddle won't move any further back, it's as far as I can get it to go, the plumb line drops about 2cm in front of the axel. I've not been cycling long, so it's all new to me!
 
OP
OP
Aston

Aston

Well-Known Member
Apparently the plumb line thing isn’t necessarily a thing any more especially when lots of bike fitters suggest fitting your cleats as far back as they will go.
Are you having issues with your current position if not why change.

No cleats, not having any issues, but TBH, I've only cycled maybe 200 miles on it so far. I'm maybe just obsessing a bit!
 

fossyant

Ride It Like You Stole It!
Location
South Manchester
The Badger says it should be around the axel as a starting point, and you get the formula for saddle height. My bikes are all set up according to his book - Racing and Training Techniques. (I am old though).
 

Drago

Legendary Member
Location
The Urban Fringe
To answer your question...

It's not a big deal.

If its comfortable and not causing injury, youre fine. No point being in the most surgically efficient position if its not as comfortable as a slightly different set up. Pro racers will settle for discomfort, within reason, where required in the pursuit of maximum performance but us normal Joe's and Jane's don't have to. Use it as a starting point rather than a blueprint.
 
Top Bottom