Pinarello Angliru.

Page may contain affiliate links. Please see terms for details.
OP
OP
Illaveago

Illaveago

Guru
I have got my stickers and started to apply them . Trouble is the down tube one is going downhill slightly. I will have to see if they can make me another one. They are not waterslide ones so they are a bit tricky to line up.

IMG_20260623_090003.jpg
 
Last edited:

T4tomo

Legendary Member
Looks fine from here looking at it on a phone!
 
OP
OP
Illaveago

Illaveago

Guru
Oh I am a numpty ! I had noticed that the letters appeared to be lifting and air bubbles were appearing. I kept on smoothing them down but they kept coming back. The stickers were rough textured and I thought that I would have to spray several coats of clear 2 pack over them. As I am thinking of removing the sticker that went wrong I thought I would try lifting it to see if it was stuck. I I pulled on the plastic I noticed that the letter was still stuck on the frame. The rough clear vinyl was just the carrier material and needed removing. The stickers look a lot better now!

IMG_20260624_160520.jpg
 
Last edited:
OP
OP
Illaveago

Illaveago

Guru
It is getting there slowly. The bike has come a long way from the corroded measled bike that I bought a while ago. There were some parts which were seized but have managed to free them. The light at the end of the tunnel is starting to get bigger. I have had to spend a bit on parts , paint, and stickers. The printers had to redo my artwork but used them to produce the correct fonts and size. They have cost £45 including vat which I don't think is bad as I couldn't find them anywhere online.
 
OP
OP
Illaveago

Illaveago

Guru
I think I might have added to today's record temperatures as I took my frame outside with a heat gun and removed the sticker. I carefully measured where the new one should go and stuck it on. I am now happy!

IMG_20260625_101655.jpg


IMG_20260625_103345.jpg
 
Top Bottom