Hi,
I've had an issue trying to run a Bkool Classic (with ANT+ FE-C enabled so an app can control it) with the Zwift program's new workout mode. It's behaving in a manner very similar to that issue reported for trainerroad too...
In Workout ERG mode, the app sets the resistance of the unit to match the power demanded for that segment - and allows a little bit of variation so the user can drop a bit above and bellow the power required. However, the resistance set by the Bkool is far higher and the power output is around 20% more than needed.
For example, one segment needed 240W, but the trainer kept me about 290W, when the next segment was 270W, it kept me around 330W
Just wondering if the same thing is the case for other bkool units?
I've had an issue trying to run a Bkool Classic (with ANT+ FE-C enabled so an app can control it) with the Zwift program's new workout mode. It's behaving in a manner very similar to that issue reported for trainerroad too...
In Workout ERG mode, the app sets the resistance of the unit to match the power demanded for that segment - and allows a little bit of variation so the user can drop a bit above and bellow the power required. However, the resistance set by the Bkool is far higher and the power output is around 20% more than needed.
For example, one segment needed 240W, but the trainer kept me about 290W, when the next segment was 270W, it kept me around 330W
Just wondering if the same thing is the case for other bkool units?