GlenBen
Über Member
Ive had a problem for a while now with my rear v brake. When the lever is pulled its fine. However, when i release the lever, the cable doesnt go tight again, it just hangs there all limp. It does release enough that the brake doesnt rub though.
Heres what i have tried already.
Removing the brake arms, regreasing and replacing.
Recabling, inner and outer.
Switching the cable to the opposite lever
Replacing the noodle and rubber bit.
Greasing the cables (pre and post changing)
Any thoughts? Ive done everything i can think of except changing the actual brakes, but the springs feel fine and pop straight back when pushed by hand.
Heres what i have tried already.
Removing the brake arms, regreasing and replacing.
Recabling, inner and outer.
Switching the cable to the opposite lever
Replacing the noodle and rubber bit.
Greasing the cables (pre and post changing)
Any thoughts? Ive done everything i can think of except changing the actual brakes, but the springs feel fine and pop straight back when pushed by hand.