eldrep
New Member
- Location
- Napton, Warwickshire
Hi All,
I have set myself up with a Bkool Smart Pro, iPad Air 2, Zwift (and Mobile Link)...and a bike....connected via Bluetooth.
1) I can only connect my trainer as a power meter, until I connect with Mobile Link, and then it shows as power, cadence and smart trainer!
2) Whilst cycling on a flat/slight downhill section, it seems very hard work for such a section, and when I go uphill, the resistance doesn't change. If I just keep going at the same cadence then all that changes is my speed and power according to Zwift.
Am I doing something massively wrong, or do I need to get a laptop (need 64 bit now apparently) and connect through ANT+ to get full comms between software and trainer?
Thanks for any help
Cheers
Phil
I have set myself up with a Bkool Smart Pro, iPad Air 2, Zwift (and Mobile Link)...and a bike....connected via Bluetooth.
1) I can only connect my trainer as a power meter, until I connect with Mobile Link, and then it shows as power, cadence and smart trainer!
2) Whilst cycling on a flat/slight downhill section, it seems very hard work for such a section, and when I go uphill, the resistance doesn't change. If I just keep going at the same cadence then all that changes is my speed and power according to Zwift.
Am I doing something massively wrong, or do I need to get a laptop (need 64 bit now apparently) and connect through ANT+ to get full comms between software and trainer?
Thanks for any help
Cheers
Phil