Hollowtech II

Discussion in 'Bicycle Mechanics and Repairs' started by BSRU, 14 Aug 2012.

  1. BSRU

    BSRU A Human Being

    Location:
    Swindon
    Are all Hollowtech II bottom brackets equivalent, assuming they are for same diameter hole?

    My Hollowtech II is a bit noisy, so I intend to clean and re-grease it to see it helps but contemplating a new one if that fails to sort it out.
     
  2. JiMBR

    JiMBR Senior Member

    Location:
    Glasgow
    Yes, as long as the width matches your current one (68mm presumably) you should be OK.
    I've just replaced one on my road bike, as it was less than £20 for a new one.
     
  3. OP
    OP
    BSRU

    BSRU A Human Being

    Location:
    Swindon
    Thanks, I also found Sheldon Brown had the same answer.
    Treating myself to an upgrade to a Dura-Ace BB for just £28^_^ .
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice