- SOLD: Wheels: 700c/29" 6-bolt, QR - Mavic XM319/Formula, XDdriver, taped for tubeless.


Über Member
West Sussex, UK
As titled, I've a pair of 700c/29er wheels for sale, stock wheels from my CX bike:

- Mavic XM319 rims (19mm int width), built onto
- Formula OEM 6-bolt QR disc hubs, with
- Sram XD driver body fitted
- Ready taped for tubeless (freshly re-taped): just add valves and sealant and you're good to go
- QR skewers included

Straight radially and laterally with only minor handling marks and no edge or bead damage. Very light scoring to the internal corners from trimming previous Gorilla Tape tubeless job. Just 1,700 miles from new and sealed cartridge bearings are still good, as is the free-hub.

Not the lightest but very strong and haven't needed truing yet. Freshly re-taped with Tesa tape (same as Stan's) over Michelin soft rim-strips, so no issues with tape perfs at the spoke-holes. Just add tubeless valves and sealant, or run them as is with tubes. While not sold as 'tubeless-ready' I had no issues mounting Gravel King SKs with Magic Milk sealant. Bit of shaking and spinning and once the rim-joint sealed they were fine.

£80 collected from Horsham, West Sussex, or post at buyer's expense. Approx £11 for insured shipping. I've a wheel box to post them in too so should get to you in decent condition.

Also available - prices only apply if purchased with wheelset:

- 2x Schwalbe 'Rapid Rob' 35mm tyres (wire bead), <30 miles: £10 (only available for collection)
- 2x Sram 'Centerline' 160mm 6-bolt rotors, good condition and pretty straight: £20

That’s £110 for the lot, collected.

Last edited:


Hello there
Could I get first dibs on these?
Top Bottom