Thinnest angle grinder disc

[clid61]

What would be appropriate to split a frame lengthways ?

 

[clid61]

Btw the way have tried big to small to medium to in between , its steel

 

[classic33]

Dremel and cutting disc.
Assuming you want both halves.

 

[clid61]

Dremel and cutting disc.
Assuming you want both halves.

Yeah both halves but a bit heavier than Dremill , Dremill be ok Ali , but steel ? Any advice

 

[clid61]

Obviously clamping securely will help but that's no issue

 

[classic33]

Yeah both halves but a bit heavier than Dremill , Dremill be ok Ali , but steel ? Any advice

https://www.screwfix.com/p/erbauer-stainless-steel-cutting-discs-4-115mm-x-1-x-22-2mm-10-pack/111jr

Cutting inside the main frame triangle won't be easy

 

[Milkfloat]

I have used these before on 4mm steel. https://www.toolstation.com/norton-extra-thin-08mm-metal-cutting-disc/p97574

 

[T4tomo]

Btw the way have tried big to small to medium to in between , its steel

and the results were?

is this a project to get internally routed cables, if so i think you may be approaching it from the wrong side....

 

[clid61]

Looking forward to the project photos.

It's all swimming around in my Gene Pool at Mo but may gel at some point ?)

 

[clid61]

and the results were?

is this a project to get internally routed cables, if so i think you may be approaching it from the wrong side....

No cables aesthetics

 

[clid61]

Looking forward to the project photos.

You'll get some , may end end up in one of that damien duffy art at some point

 

[clid61]

Im experimenting with grinding discs before I sand them

 

[classic33]

Im experimenting with grinding discs before I sand them

Why grinding discs when cutting discs are required. They're thicker by a long shot.

 

[classic33]

Start cutting on the inside of the main triangle, followed by the rear of the head tube, and the inside of the seat tube.

 

[numbnuts]

waterjet cutting, but not for home use, well if you have a lot of money to spare