Cutting mudguard stsys

[Fifelad]

What’s the best thing to trim the stays hacksaw is going to take forever what about what tin smiths snips ? think they are called.

 

[OldShep]

I’ve used bolt cutters and also a Dremel with a cutting wheel both were quick and satisfactory.

 

[Yellow Saddle]

What’s the best thing to trim the stays hacksaw is going to take forever what about what tin smiths snips ? think they are called.

Dont abuse your tools. Tin snips are for thin sheet metal. Those stays are hard, stainless wire in most cases. Cut them with a side-cutter and file the tip flat or, use a Dremel, but still file the burr off.

 

[wiggydiggy]

What’s the best thing to trim the stays hacksaw is going to take forever what about what tin smiths snips ? think they are called.

Do you mean the metal arms, are those the stays?

A decent junior hacksaw will go through those in a few seconds I'd have thought.

Snips are too small, bolt cutter will do it though.

 

[slowmotion]

1mm thick steel cutting wheel in a small angle grinder.

 

[jay clock]

a Dremel. really challenging otherwise

 

[presta]

A decent junior hacksaw will go through those in a few seconds I'd have thought.

Indeed. My guess is that he's trying to cut them without the work held in anything.

 

[Dogtrousers]

Not something I do very often. A handful of times in my life, at most. I mean, once fitted they are done. I've only done it once in recent memory, and I used a Dremel with a cutting wheel. In pre-Dremel days I probably used a hacksaw.

 

[SolemnWeasel]

I used a hacksaw, was quite hard.

 

[Paulus]

With the stays held in a vice, if you have one, or the use of one, a hacksaw, even a junior one will go through them easily.

 

[Gunk]

I’ve used bolt cutters and also a Dremel with a cutting wheel both were quick and satisfactory.

I’ve used this method, just wear some eye protection

 

[Fifelad]

Think I might just leave them 😂

 

[Drago]

Beefy side cutters.

 

[Vapin' Joe]

Do you mean the metal arms, are those the stays?

A decent junior hacksaw will go through those in a few seconds I'd have thought.

That's what I found, a junior hacksaw takes no time at all.

 

[Gwylan]

Angle grinder, quick result
Dremel with a disc might be prettier