JoeyB
Go on, tilt your head!
- Location
- Fareham, Hampshire
Bars fitted...followed by levers. I don't think they are quite level yet so might re-address that after a test ride for position preference etc
Next for my bargain wheelset. By chance I saw a link on Facebook to someone selling off Geoff Shergold's old new stock. I quick trip to Southampton and £50 later I had these..complete with rim tape and QR skewers.
Forgot to take a pic of the rear wheel fitted, there it is...over there
Getting there
Crank set next, at this point I was about to get the hammer out but then remembered I had a tool for the crank too, jobs a good'n
I quick hit with a hammer and screw driver and the lockring came off without drama, its a bit dirty in there
Quick dip in brake cleaner sorted the grim
Bearings greased up and BB refitted. Cleaned the frame up a bit as well
Next for my bargain wheelset. By chance I saw a link on Facebook to someone selling off Geoff Shergold's old new stock. I quick trip to Southampton and £50 later I had these..complete with rim tape and QR skewers.
Forgot to take a pic of the rear wheel fitted, there it is...over there
Getting there
Crank set next, at this point I was about to get the hammer out but then remembered I had a tool for the crank too, jobs a good'n
I quick hit with a hammer and screw driver and the lockring came off without drama, its a bit dirty in there
Quick dip in brake cleaner sorted the grim
Bearings greased up and BB refitted. Cleaned the frame up a bit as well