New wheels - swapping front rotor problem

Grant Fondo

Oswalds legs look strangely human?
Location
Cheshire
So, it was all going swimmingly, endpugs swapped over from thru axle to QR type, rear cassette and rotor on, but when it came to front rotor, got lockring hand tight but tool wont fit between lockring and endcap, so stuffed. Rotor wobbling about with max hand tighness.
Any suggestions?, is there a different tool i need to properly tighten lockring? :wacko:
 

fossyant

Ride It Like You Stole It!
Location
South Manchester
Pop the end plug off then tighten
 

I like Skol

Hold my beer and watch this....
I have an Ice toolz one that is much deeper than normal and also fits on a 1/2" breaker bar which is 30" long so no problems getting stubborn ones undone (although they shouldn't be that tight!).
 
Top Bottom